up: Chapter 17 -- 80386 Instruction Set
prev: LOOP/LOOPcond Loop Control with CX Counter
next: LTR Load Task Register


LSL -- Load Segment Limit

Opcode       Instruction      Clocks      Description

0F  03 /r    LSL r16,r/m16    pm=20/21    Load: r16 := segment limit,
                                          selector r/m16 (byte granular)
0F  03 /r    LSL r32,r/m32    pm=20/21    Load: r32 := segment limit,
                                          selector r/m32 (byte granular)
0F  03 /r    LSL r16,r/m16    pm=25/26    Load: r16 := segment limit,
                                          selector r/m16 (page granular)
0F  03 /r    LSL r32,r/m32    pm=25/26    Load: r32 := segment limit,
                                          selector r/m32 (page granular)

Description

The LSL instruction loads a register with an unscrambled segment limit, and sets ZF to 1, provided that the source selector is visible at the CPL weakened by RPL, and that the descriptor is a type accepted by LSL. Otherwise, ZF is cleared to 0, and the destination register is unchanged. The segment limit is loaded as a byte granular value. If the descriptor has a page granular segment limit, LSL will translate it to a byte limit before loading it in the destination register (shift left 12 the 20-bit "raw" limit from descriptor, then OR with 00000FFFH).

The 32-bit forms of this instruction store the 32-bit byte granular limit in the 16-bit destination register.

Code and data segment descriptors are valid for LSL.

The valid special segment and gate descriptor types for LSL are given in the following table:

Type   Name                      Valid/Invalid

  0    Invalid                   Invalid
  1    Available 80286 TSS       Valid
  2    LDT                       Valid
  3    Busy 80286 TSS            Valid
  4    80286 call gate           Invalid
  5    80286/80386 task gate     Invalid
  6    80286 trap gate           Invalid
  7    80286 interrupt gate      Invalid
  8    Invalid                   Valid
  9    Available 80386 TSS       Valid
  A    Invalid                   Invalid
  B    Busy 80386 TSS            Valid
  C    80386 call gate           Invalid
  D    Invalid                   Invalid
  E    80386 trap gate           Invalid
  F    80386 interrupt gate      Invalid

Flags Affected

ZF as described above

Protected Mode Exceptions

#GP(0) for an illegal memory operand effective address in the CS, DS, ES, FS, or GS segments; #SS(0) for an illegal address in the SS segment; #PF(fault-code) for a page fault

Real Address Mode Exceptions

Interrupt 6; LSL is not recognized in Real Address Mode

Virtual 8086 Mode Exceptions

Same exceptions as in Real Address Mode


up: Chapter 17 -- 80386 Instruction Set
prev: LOOP/LOOPcond Loop Control with CX Counter
next: LTR Load Task Register